Looking to add a little functional style to your office? Why not post up your calendar or track a to-do list on in which metallic copper message board! A little copper sheeting by the hardware store goes a long way in adding a hint of bling in addition to also loads of design savvy to any space. Let’s get started out!
- Copper sheeting
- Heavy duty scissors
- T-square + Permanent marker
- 4 stand-off screws
- Screws for the wall
- Electric drill + diamond drill bit
- Duct tape (optional)
- Chalkboard pens
Cut the copper sheeting down to the size you’d like your message board to be. in which message board can be roughly 12″ x 18″. Leave the protective film on the metal sheet.
Mark the locations on the backside of the metal sheet (the side without the film) for the stand-off screws in each of the 4 corners of the board using a t-square in addition to also permanent marker. Here the screws are positioned 1.5″ by the top edge in addition to also side edge of the board. If your message board can be quite a bit larger than the one shown, you may want to add additional stand-off screws at the midpoint of each side to provide more stability.
Use an electric drill fitted which has a diamond drill bit to drill holes at each of the four marks made in step 3. Position the sheeting so the idea’s cantilevered over the edge of the table. Drill by the backside (the side without the film) in addition to also drill the hole only large enough for the standoff screw to fit through. The hole will be jagged, nevertheless in which’s okay. The stand-off screw will cover the opening. You may want to wear heavy duty gloves, as you’ll be working which has a few metal shards.
Peel the film off the face of the metal sheet.
Position your message board within the spot you’d like to hang the idea on the wall. Use a level to make sure the idea’s straight. I found the idea helpful to use a little duct tape to hold the idea in place while doing so.
Use the 4 holes created in Step 3 to mark on the wall the drill locations for the stand-off screws.
Use your electric drill fitted which has a drill bit just smaller than your wall screw to drill holes within the 4 locations marked in Step 6.
Remove the front screw piece by the stand-off screw. Insert the wall screw into the back piece of the stand-off screw so the idea sticks out the back end. Screw within the screw in addition to also back piece to the wall. You may need to use a handheld screw driver at the end to get the idea tight to the wall. Repeat with remaining 3 screws.
Place the front stand-off screw pieces through the metal sheet holes, in addition to also screw into the back pieces in which are attached to the wall. the idea’s helpful to get all four screws started out in addition to also then tighten them all to finish.
Last nevertheless not least, write a message on your brand-new message board! Here I’ve created a calendar I can switch out each month, nevertheless a to-do list or inspirational quote would likely also be fantastic!
Tags: #Decorative Kitchen Message Boards #Decorative Wall Message Boards #Kitchen Message Board Organizer #Kitchen Wall Organizer Message Center #Message Board Wall Ideas #Message Board Wall Organizer #South Jersey Dirt Racing Message #Wall Hanging Message Boards